ERR6600 | Multi-Point Fuel Injector - V8 EFi | Discovery 2, Range Rover P38
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
Land Rover Part Number: ERR6600 - Multi-Point Fuel Injector
ERR6600 is a multi-point fuel injector fitted to the fuel injection rail on Rover V8 EFi engines. It delivers pressurised, metered fuel to each individual intake port under electronic control and includes O-rings to seal the injector at the fuel rail and the intake manifold. Correct spray pattern and flow rate are important for even combustion, drivability and emissions control; replacement injectors should match the original electrical connector type and flow specification to maintain performance and avoid diagnostic faults.
Use the compatibility data below to confirm fitment against your V.I.N.
Compatibility
- Discovery 2 (1998-2004) - V8 Petrol EFi
- Range Rover P38 - V8 Petrol EFi (From VIN XA410482)
Frequently Asked Questions
ERR6600 meters and delivers pressurised fuel to each cylinder on Rover V8 engines equipped with electronic fuel injection. The injector opens for short, controlled periods to atomise fuel into the intake port so the correct air-fuel mixture can form; the unit is sealed by O-rings at the rail and manifold. Using the correct connector and flow-rating is important to avoid drivability problems or engine management faults.
| Model | Variant |
|---|---|
| Land Rover Discovery 2 (1998-2004) | V8 Petrol EFi |
| Land Rover Range Rover P38 | V8 Petrol EFi (From VIN XA410482) |
If you are unsure of compatibility with your vehicle, you can also confirm by checking against your V.I.N. Simply reach out to us with your V.I.N and desired part number via our Contact page or use our Finding Part Numbers page.
Inspect injectors during routine engine servicing and replace any unit that is leaking, shows a poor spray pattern, causes misfire or triggers engine management fault codes. If unsure, confirm correct fitment and flow specification against the vehicle VIN before replacing.
- C8 products are usually supplied by Britpart.
- L8 products are genuine Land Rover parts.
- Z8 products are normally supplied by Allmakes.
All products and accessories available on LRDirect.com come with a 2-year warranty.