FTC1724 | Right-Hand Rear Halfshaft - Defender 110, 130 1994-2002
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
Land Rover Part Number: FTC1724 - Right-Hand Rear Halfshaft
FTC1724 is a right-hand rear halfshaft that transmits torque from the rear differential output flange to the right-hand rear wheel on long-wheelbase Defender 110 and 130 models. The shaft includes the splined connections and bearing interfaces required to engage with the differential and the wheel hub while allowing for suspension movement and axle articulation; failure or excessive wear can cause vibration, noise under load or loss of drive.
Use the compatibility data below to confirm fitment against your V.I.N.
When replacing a halfshaft, check the matching side and wheel-end components for wear and confirm the VIN range to match axle and hub variants. This assembly is specified for long-wheelbase Defender 110 and 130 vehicles within the listed VIN range and is fitted to the rear axle assembly where halfshaft lengths and spline counts are specific to those models.
Compatibility
- Defender (1994-2002) - 110 & 130 - From VIN LA930456 to VIN 2A638133
Frequently Asked Questions
FTC1724 is the right-hand rear halfshaft that carries drive torque from the rear differential output flange to the right-hand rear wheel on long-wheelbase Defender 110 and 130 models. It uses splined connections and bearing interfaces to engage the differential and hub while permitting suspension movement and axle articulation. Inspect mating hub and differential components when fitting, and confirm the vehicle VIN matches the listed axle and hub variant to avoid incorrect length or spline count.
| Model | Variant |
|---|---|
| Land Rover Defender (1987-2006) | Hubs & Driveshafts - From VIN LA930456 |
| Land Rover Defender (1994-2002) - 110 & 130 | From VIN LA930456 to VIN 2A638133 |
If you are unsure of compatibility with your vehicle, you can also confirm by checking against your V.I.N. Simply reach out to us with your V.I.N and desired part number via our Contact page or use our Finding Part Numbers page.
- C8 products are usually supplied by Britpart.
- L8 products are genuine Land Rover parts.
- Z8 products are normally supplied by Allmakes.
All products and accessories available on LRDirect.com come with a 2-year warranty.