RFD100000 | Staked Wheel Hub Lock Nut - Front & Rear Hub | Defender 1987-2016
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
To check the stock of Genuine Parts before placing an order please use our Contact Us page
Land Rover Part Number: RFD100000 - Staked Wheel Hub Lock Nut
RFD100000 is a staked wheel hub lock nut used to retain the hub bearing on Defender front and rear hubs. The nut has a thin top section which is deformed (staked) with a hammer and punch after the final torque is applied to lock the nut in place and prevent it from loosening in service.
Please note: Staked type with a thin top section that must be deformed by hammer and punch after the nut is torqued; axle codes 10M to 17M. Some early models used two of part number FRC8700 instead of this lock nut.
Compatibility
- Defender (1987-2006) - Front Hub (From VIN LA930456)
- Defender (2007-2016) - Front Axle Hub (From VIN 7A000001)
- Defender (1994-2016) - Rear Hub (From VIN XA159807)
Frequently Asked Questions
RFD100000 secures the hub assembly by retaining the hub bearing on Defender front and rear hubs. Once torqued to the required specification, the nut's thin top is staked over with a hammer and punch to prevent it from backing off during operation; axle codes 10M to 17M use this staked type, while some earlier vehicles used two FRC8700 nuts instead.
| Model | Variant |
|---|---|
| Land Rover Defender (1987-2006) | Front Hub - From VIN LA930456 |
| Land Rover Defender (1994-2016) | Rear Hub - From VIN XA159807 |
| Land Rover Defender (2007-2016) | Front Axle Hub - From VIN 7A000001 |
If you are unsure of compatibility with your vehicle, you can also confirm by checking against your V.I.N. Simply reach out to us with your V.I.N and desired part number via our Contact page or use our Finding Part Numbers page.
Replace the nut whenever it is damaged, when the staking has been disturbed or removed, or when fitting a new hub or bearing; the nut is a staked type and must be re-staked after installation, so replacement is standard practice during hub/bearing renewal.
- C8 products are usually supplied by Britpart.
- Z8 products are normally supplied by Allmakes.
All products and accessories available on LRDirect.com come with a 2-year warranty.